Installation

Wiring:

The wiring is mostly unchanged from what I had in place for the original car-computer. I already had serial and audio cables ran to the trunk. The old system used power, ground and a switching wire that triggers a relay. The new system is powered the same way. The only thing that needed to be done was to re-route the wires, then attach an Anderson Powerpole connector to the power wires. The picture below shows the old car-computer on the far right.

[Old Car Computer]


Mounting:

Because of its smaller size, I was able to mount the new car-computer above the speakers. I already had a spacer board. I fabricated a computer mount by adding onto it, then attaching it to the car using large thumbscrews.

[New Car Computer]



Last Update: 10-02-2018