what to do if it says no joystick found

Started by jerry, February 05, 2012, 04:51:56 PM

Previous topic - Next topic

jerry

got a little 486 laptop with w95 on it, running your software in a dosbox, elm323 with homebrew interface. any ideas?
thanks

admin

If you use the /gpp command switch, the program will run a hardware detection routine to see if a Gravis Gamepad Pro joystick is connected.  If it doesn't find one, then it'll complain that there's no joystick.   That's the only time that message is supposed to be displayed.

Are you using any command switches?

Quick Reply

Name:
Email:
Verification:
Please leave this box empty:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
write the numbers seen in 7asA2DD8azmzme1:
first two letters in 7777nazzz88zuz:
Shortcuts: ALT+S post or ALT+P preview